🔥 Enhance Spark Performance with PerTronix 40111 Flame-Thrower 40,000V 1.5 Ohm Coil - Black Review

installed on an AMC 304. After I installed the coil my motor system was no longer reliable. The electrical system just shut down suddenly. The system also failed and shut down under heavy loads such as hard acceleration and hill climbing. The instructions say don't use a ballast resistor and you could open a gap in the connector that will stress the coil. So I reinstalled the ballast resistor and reset the connector to stock to see if that would improve the behavior of the coils. It became…

Installed 40111 Epoxy Coil in a 1929 Ford Model A, 6 volt with unmodified switchgear. I wanted to check the intensity of the spark, so I held the coil wire next to the block while cranking. It used to be a solid 1/4 inch spark. She now jumps a 3/8 inch gap. Very noticeable change in soft start at idle. I set the congestion to 0.040 and the highway speed now has more throttle and smoother operation. i am sold All my friends buy this role. I used epoxy instead of oil because the spool ran upside…

I bought it for my boat. He has a Ford 302 with a Prestolite distributor fitted with a PerTronix ignition kit. I installed a new coil according to the instructions and everything worked. I've had a good ride on the water for several days, probably spent a total of 3.5 hours on it. Luckily arrived at the port it was a quiet evening, he passed out 100%, dead! Had to be towed to dock. When it worked it was noticeably better than the original coil, much smoother and more powerful. But dead is NOT…