🔪 Enhanced Precision with Raised Panel Router Back Cutter! Review

This router bit did not perform as advertised and produced subpar results. The quality of the cut was disappointing and left rough edges on the material. The only positive aspect of this product is its relatively affordable price. However, considering its inferior performance, it's not worth the investment. As an Industrial and Scientific product, I expected better quality and accuracy. I would not recommend this product to anyone.

Just over 50 3/4" MDF boards were embossed with this die using a single pass per side. via my diamond sharpener a few times before use and then lowered the router speed to 4. DO NOT be stupid and expect the same quality as a $75 bit, but for the price you won't beat the value. Also note that these router bits for Panel Up don't cut as deep as form routers, but that's what we wanted and the router bit worked great.

This is one massive attachment! It's so big I built a shed for it in my backyard. Make sure to run this thing at a snail's pace; Otherwise the massive bullet of this behemoth could penetrate your body. Don't list all the people yelling about the quality of this router for under $100. Little do you know you get what you pay for. I'm betting on saving some green by spending significantly less money on this incredible Hulk cutter. He did exactly what he had to do. Don't forget to give this cutter…