Header banner
Revain logoHome Page
🔧 rannb 3-inch pipe drill opener plate logo

🔧 Rannb 3-Inch Pipe Drill Opener Plate Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.7
🪚 Hole Saws & Accessories, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(4)
img 1 attached to 🔧 Rannb 3-Inch Pipe Drill Opener Plate
img 2 attached to 🔧 Rannb 3-Inch Pipe Drill Opener Plate
img 3 attached to 🔧 Rannb 3-Inch Pipe Drill Opener Plate
img 4 attached to 🔧 Rannb 3-Inch Pipe Drill Opener Plate

Description of 🔧 Rannb 3-Inch Pipe Drill Opener Plate

◼ 【Material】The hole saws are made of M42 Bi-Metal ,offering a combination of hardness and toughness for wear resistance. ◼ 【Efficiency】Each drill bit is equipped with small holes around the wall, which can improve the speed to expel the chips when working. ◼ 【Sharp Teeth】The teeth is sharp and vibarition is less, which enable more stable operation and make the hole can be cut with quick speed and balance. ◼ 【Spring Loaded】The hole saw dirll bit is attached with spring. It can automatically pushes the disc out of the saw immediately after completing the hole. ◼ 【Wide Application】Suitable for Pistol Drill, Bench Drill,Vertical Drilling Machine etc. Widely used in Plate Hole, Home Wood, Galvanized Pipe, Fire Pipe, Plastic, Gypsum Board and Other Opening Operation.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    2
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

Not Sharp Enough: Power Tool Parts and Accessories

I bought several different drill bits of different sizes to carve a ring in hardwood. It wasn't sharp enough and broke the tree. Another set (different brand, material, and edges) burned wood, so maybe it just wasn't the right tool for the job. It might cut cleanly and accurately on softer woods, but I didn't get it.

Pros
  • Power Tools and Hand Tools
Cons
  • I don't remember, but there was something

Revainrating 5 out of 5

So Far So Good - Power Tool Parts & Accessories

The spring pushes out most notches. Slots allow you to remove the ones that just don't show up. Hex bits work well. In addition to inch sizes, you have a pretty good selection of different sized holes in metal and plastic. I prefer Forstener bits for wood and some plastics. that drilling a small diameter hole facilitates chip evacuation and speeds up drilling.

Pros
  • Power Tool Parts & Accessories
Cons
  • No Job

Revainrating 3 out of 5

Not Sharp Enough - Power & Hand Tools

I bought these to install some buttons for an arcade setup that were metric. They are true to size. I used them on MDF. They burned firewood very badly. I don't mind this as I will be putting buttons through the holes, but this may not work for everyone. They also "blown out" the back of the hole. I tried to be very careful when I got to the end, but the top layer of wood came loose about 1-2 inches around the hole as it worked its way to the back of the hole. It didn't make much of a…

Pros
  • Tools & Housewares
Cons
  • Some Bugs