🔌 Dishwasher Fuse Kit - ERP 8193762 Enhanced with SEO Review

If it stops working completely, this fuse is the likely cause. Be sure to use the lego shaped terminal block to install the new terminals in the kit - do not just replace the fuse part - or the new fuse could blow. The old terminals were badly designed.

I liked it on the second purchase, but on the previous purchase of the same product I didn't cut out the old plugs and only installed a fuse. NOT CORRECT! Do yourself a favor, CUT OFF the old plugs and follow the instructions. Now it works great! Have fun with Matt

My Whirlpool dishwasher no longer works. Well, of course I found out. I found that the thermal fuse that powers the door switch was open. I replaced it with this one on Amazon and it has been working great for the past 2 months. Just follow the instructions and don't remove the fuse quick disconnects. Cut the wires in the dishwasher and connect them to the screw terminals included in this kit.

My Kenmore Dishwasher is starting to blow fuses. Replaced control unit, fuses still blown. Then I figured out how to turn off the auto drying element, thinking that might be the reason. 6 months without backup! Then it started again. I just bought a larger supply of fuses. Could change her with her eyes closed. As a result, he left Kenmore and took Bosch. Tip: Before trying this, ask a technician to change it for you the first time and watch it closely.

This repair saved me from contacting the service and from a lot of problems. BE SURE TO CUT THE WIRES ACCORDING TO THE INSTRUCTIONS! If you don't change the wires, that new fuse will blow and you'll have to order another one (at your expense for not following the instructions - ask my husband how we know lol). The instructions are clear and the repair took less than 10 minutes. You have no idea how much you miss your dishwasher until this inexpensive item is gone. Don't waste more money than…

It took me two tries to get it right. After the first item arrived I just replaced the fuse because changing the wiring harness seemed like a waste of time when the wiring was fine. The fuse blew on the first wash. So I ordered the kit again, but this time I followed the instructions and used the included wiring harness and mylar tape. I've only run the dishwasher once, but it worked great. I can't explain why using the wiring harness made a difference, but it seems to have fixed the issue for…

Update: 4/6/2015 It's been a little over a year since I installed this fuse and the machine isn't working again. I haven't checked if this is the same issue, but I suspect it is. I'll try to find a fuse that's a hair's breadth stronger, but if not, I'll try this one again. Pretty simple solution. Is working. I installed it a few months ago and it immediately solved the no power issue. Braids are included. I don't know if it's due to a little more resistance or a better connection, but it worked

I have a stainless steel KitchenAid that is probably 10 years old. I've done many repairs, but this one amazed me. It stopped in the middle of a cycle. But my first test of this fuse showed it was a good conductor and when I turned the washing machine back on the control panel lit up and I started it again. Another error in the middle of the loop. This time the fuse blew. The replacement is not difficult, and there are videos on the Internet on how to do it. Two full cycles so far and all is…