🔝 Maximize Rigging Efficiency with Rig Rite 610 Rigging Grommet 1 Review

I recently bought a car that I've wanted for a long time, a BMW Z3 convertible. The previous owner replaced the radio antenna and the replacement did not have a grommet so the hole in the rear fender sheet metal was just a hole. This worked great for sliding over the antenna and resting the base of the antenna against the wing, keeping it relatively waterproof and looking a lot better.

Nice decorative ring to close the hole where I wanted to put the extension through the wall. Due to the small diameter of the hole, I used wire cutters to "cut" one side of the perimeter so I could thread the cord through the center of the grommet and then screw it to the wall. The hole was too small to put the end of the connector through without a notch.

The description of the item is a bit ambiguous as it implies that I will be buying a 3 piece set. I actually have to state that these different sizes are available but do not constitute a set as I only received one socket. There is even a picture of three different sizes in the product description. Let the buyer be alert!