📱 20-Inch E-Series Cradle Mount Review

I don't know how to rate it. It doesn't fit my 2019 Jeep Wrangler with steel bumper. You will need to drill holes in either the bumper or the bracket itself.

I ended up sending this back, but only because I couldn't put the 20" lightbar where I wanted it. It would be perfect if I had another 2-3 inches of width on my front bumper.

made of soft metal and cheap paint to boot. I installed this on my Jeep and when I had to pry one end off a bit to bend my light strip like it was made out of an LED or something, when I tapped it to straighten it the paint came off, like that simple, it made me regret the purchase and thought I should have made my own mount. I have a vague suspicion that this is made in China. This is not good for Rigid because I have a lot of confidence in their American made products.

Used this bracket to install a 20" E2 hard light on a 2014 Ford Raptor. No instructions come with the unit and holes need to be drilled to mount the bracket and a small cutout in the small plastic bumper on each side.Measuring the holes and making sure the unit is level is very difficult as space is limited.Also I had to use additional shims to ensure the headlight stays flush with the bumper, otherwise the headlight would sink into the bumper.

I bought this for my DV8 front bumper on a 2016 Jeep JK. Mounting holes do not match. I could drill my own holes, but what's the point? I might as well take a piece of metal and build my own mount when I get to that point, but I won't do it. What I don't understand is that the 10" mount has multiple hole configurations for multiple bumpers. This model and this size do not give the same attention. I am returning it and now have to look for hood mounts as I have a 20" hard light bar and have…

While I was hoping to get by with the short mounting brackets that come with my RI 20" Spot/Flood (which I LOVE!), I found that they just aren't enough. Versatile for mounting. I resorted to purchasing this separate mount. I have a simple 3 sided mount. No fancy plasma cutouts. Not a big deal, but not that spectacular, and my light bar is mounted at the very front of my quad and is easily visible. Second, why doesn't RI just pop in the required bracket with the light? After all, I just forked…