🔧 SPACECARE 600 Side Retractable Casters for Workbenches and Equipment Review

So I don't often leave negative reviews, but I have no other way to contact the seller. First, I followed the directions for the T and the wheels don't rise to the correct height. Second, the bolts are already flexing, and so is the lever (at the turning point). The rating goes beyond the scale, it can be halved. Since the wheels don't lift, they don't spin either, making it almost impossible to move my desktop around. **Update: After about a week I still haven't contacted anyone for customer…

First of all all the products work as advertised, when I received mine it was short, three screws with no problems, I had plenty of these in my shop but it does the job not It doesn't help my opinion of the product, especially when I broke two screws when I installed it. Installing the casters wasn't a difficult task, but if you're expecting all the hardware to be there, it can be an issue. Once installed, it does the job, but the steel isn't the best quality. just click, which requires some…

Bought for my workbench. Installation was pretty easy - the instructions say 1 inch from the end of the leg to the bottom hole. They do not notice that this distance refers to a 2-hole template. If you're using a 4-hole jig, the bottom screw holes are slightly higher and you'll need to adjust the hole positions accordingly. Also, the instructions mention washers, which weren't included and don't appear to be needed for the casters to work on my 150 lb workbench rolled very easily to where I…

These rollers are fine. They seem robust enough for my needs: moving around my desktop. The metal step is a bit flimsy and I am very careful when I have to lift the table not to bend it. IMPORTANT NOTE: I recommend buying your own screws as the ones that come with his product are of poor quality. I broke 5 during installation (see attached photos). I was able to pull out 3, the other 2 should have stayed at the foot of my workbench. The good thing is that it has 3 screw holes. If the middle one

I bought these to match my Harbor Freight carpentry table. I liked the idea of taking the bench off the rollers and letting it sit on its own weight so I can apply force to keep it from sawing, planing, and gouging. They fit the legs perfectly and were fairly easy to install (with one exception that will be discussed later). There are actually six screw holes, not four (three at the top and three at the bottom of the wheel). To install I simply lined them up, marked the holes with a pencil and…

Like many American consumers, I have more "things" than I have room for. For years the radial saw inherited from my father sat in the corner of the garage because it was too heavy and bulky to move. These wheels have given it new life as I can put it in a corner, then wheel it outside for use, then roll it aside for storage. This kit comes with hardware. screwed to the wooden legs of the bench and the saw mounted on a rectangular steel frame. So first thing I went to the hardware store and…