🚗 MOTOKU Car Engine Start Stop Button Switch Cover Cap For BMW 5 6 7 Series F01 F02 F10 F11 F12 F13 2009-2013 Review

Remove panel, remove 3 torx screws. Remove the retaining clip, and then insert the clips that hold the button in place. easy installation and excellent product quality. Installed on a 2011 535i.

Replaced when installing the center air vent. It took about 2 minutes to undo the screws holding the switch and take out the plastic holding this cover. Looks like new and works great.

Perfect fit, looks great! I installed it on a 2011 740Li. You have to remove the entire panel to turn on the key. Start with the glove box and just remove it. then it would make sense. takes maybe 10-15 minutes.

This product looks and feels like a genuine part of my 2009 BMW 750Li (F02). The lettering on my start button is faded and almost gone. This product was a perfect fit, perfect replacement. Lights up like original (lettering). Good buy and I recommend it.

To be clear every button they show in the picture is the correct one for the car but that is not what you will get. I got what looked like a mini version of a real button. After removing my original one I realized that everything they sent me was bad and I had no choice but to try and get the crap out and tape it over the hole where the stop/button would normally be . What makes it even better, the lettering on the button (Start/Stop Engine) is not even centered. My car is a 2011 BMW 750I (F01)

I just installed this button cover on my 2011 750Li. I'm writing this review because I've had a lot of trouble installing this part. It's not hard, but I hate breaking the goal because I didn't know how things would fall apart. Remove the panel from the dashboard. You can do this with your hands, starting at the end of the glove box where you can grab it. It's just taken off. Notice how the latch button/four-pin wiring is routed.2. Disconnect the wiring to the switch. The plug is simply pulled…