Header banner
Revain logoHome Page
steel dragon tools annular cutter cutting tools logo

Steel Dragon Tools Annular Cutter Cutting Tools Review

2

·

Average

Revainrating 3 out of 5  
Rating 
3.0
🪚 Industrial Drill Bits, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(4)
img 1 attached to Steel Dragon Tools Annular Cutter Cutting Tools
img 2 attached to Steel Dragon Tools Annular Cutter Cutting Tools
img 3 attached to Steel Dragon Tools Annular Cutter Cutting Tools
img 4 attached to Steel Dragon Tools Annular Cutter Cutting Tools

Description of Steel Dragon Tools Annular Cutter Cutting Tools

Steel Dragon Tools 2-inch high speed steel annular cutter. Bit Size: 2 in. Cutting Depth: 2 in. 3/4 in. Weldon Shank. Machine-finish hole with no reaming needed when using lubricant.

Reviews

Global ratings 2
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 2 out of 5

Not Worth the Investment in Industrial and Scientific Tools

My analysis of this product showed that it was not a good investment for an industrial and scientific setting. The cutter did not perform well and required a lot of pressure to even make a dent in the material. It was a great disappointment, especially considering the cost .The only positive aspect was the appearance of the cutter, which looked impressive. however the lack of performance far outweighed the aesthetic appeal..

Pros
  • Durable and long-lasting
Cons
  • May dull quickly if used on hard metals

Revainrating 5 out of 5

Check cutting speed for HSS and cutter diameter. And use lots of coolant.

I appreciate the shipping box was double boxed with those fancy pillow cases in addition to the tool box it comes in. That was good. But I ordered a 2" hole cutter. This was my first experience with such a cutter. And wow, I'm impressed! I pulled it straight into 3/4" collets at Bridgeport. A pilot hole is not required. When cutting 5/8" steel flat bar, I ran it at 70 RPM, used lots of cutting fluid, and manually applied enough pressure on the quill to chip the steel at a constant rate. I…

Pros
  • Cutting Tools
Cons
  • New Competitors Appeared