🔧 Enhanced HA590600K Wheel Bearing and Hub Assembly by Timken: Optimal Performance for Smooth Driving Review

Good bearing, easy to squeeze. The retaining ring has no holes for pliers, which makes assembly difficult. I had an original Timken bearing. But bearings are expensive.

It fits our 2001 Nissan Maxima perfectly and runs from the moment it is fitted was installed, tight and quiet. I drove about 2500km with it at the moment. Timken has always been a great wheel bearing.

I ordered this set (two pieces) for a 2005 Nissan Altima. It said it was the correct fit/part number. Even crossed it in RokAvto. Did not fit. The inner diameter of the spindle hub for the shaft splines was too large. It may have been packaged incorrectly, I have no idea. As a side note, other reviewers have stated that the bearing is not a Timken bearing. That was also correct in my case. I can't remember the name stamped on the bearing but it said 'Made in Japan' and I'd happily use that if…