🖨️ TUPARKA Extruder: Your Perfect Makerbot Creality Companion Review

These aftermarket nozzles should be 0.4mm in diameter but are not. The hole on EACH NOZZLE is too small and you can't put the included needles through it without using a lot of force. If you use them as is, you'll end up extruding with the 0.4mm settings shown in the layer lines. They will work if drilled to size with a needle prior to installation. Buying 35 tips at this price might seem like a bargain, but you have to do the work of inserting the needle. But why would you do that when you can

So as the name suggests I found 1 defective nozzle out of 70 pcs. in the complex. I bought this kit because I currently have 2 printers, an Ender 3 Pro and a CR10S, and wanted to try different nozzles while working on different projects. Also, my CR10S's nozzle started clogging right before I switched to an all-metal hot end, so I figured now was the perfect time to try it and swapped out my 0.4mm nozzle for another. After trying to start the nozzle for about 2 minutes, I pulled it out only to…

I've tried about half a dozen factory CR-6 SE nozzles and never thought of trying anything else. I've been doing a few long prints (about 40 hours each) over the past few weeks and there is something metallic in the filament eating up the nozzles. I found them and at first the hole didn't look like it was the right size compared to the factory jets. I inserted the test needle and it went straight into the Creality tips but not the tuparka. I tried it a few more times and was able to get it to…