Upgrade your Vehicle with Viper 7146V - Long-Range 1 Way Car Remote featuring 4 Buttons and 1/4 Mile Range Review

Replaced the 7142v remote with this one. Thinner than the original. Happy with the replacement. Came in a small bag and no instructions, but a quick google search for programming is probably better than deciphering written instructions.

If programmed in less than a minute but not following the instructions provided. I checked under my dash to see where the remote start brain/computer is and googled the model number. I found the right guide there.

Works with my Viper Alarm and very easy to program. When trying to figure out how to call the Viper they were very helpful and it was a 30 second process for the 4 remotes I programmed. There should be instructions, but there aren't any.

Worked on my old Viper system. The original remote was 474v. I have an Escalade 05. It took me a hell of a long time to get into programming mode but I finally did after getting my car out of park mode. Did this by opening the door, then quickly turning the key, then turning off and pressing the valet button. It chirped. As soon as I heard the chirp, I was able to put it into programming mode. I did the same thing again without removing the key (open the door/turn the key quickly/press and hold

Most Viper alarms require this remote to be programmed to channel 2. Follow these steps to program the remote control.1. Sit in the driver's seat and open the driver's door.2. Put the key in the ignition and turn the key to the "on" position (do not start the engine, turn it to the position that turns on all the electronics in your car)3. Press the button on your alarm receiver ONCE, THEN PRESS THE BUTTON DOWN FOR ONE SECOND UNTIL YOU HEAR THE ALARM SEVERAL TIMES, THEN RELEASE THE BUTTON ON THE