Comprehensive XXGO 102 Pcs Oscillating Tool Sanding Triangular Finger Pads Kits: Bosch, Chicago, Craftsman, Dremel, Fein, Harbor Freight, Makita, Milwaukee, Porter Cable, Ridgid, Ryobi, Rockwell Compatible XG3102 Review

I've used this a half dozen times since I received the kit a few weeks ago and it works well. It goes well with my Chicago multi-tool. The way to use this to extend pad life is to let the tool do its job. Use a low average and apply light pressure. If you press too hard, you will heat the pad, which will shorten the life of the pad and sandpaper.

Poor quality pads, fall apart fairly quickly. The fingertip only lasted a few minutes and the rim melted after the first twist. See I'm not trying too hard, it was just a light 240 grit corner sanding. Although not as bad as the pads, the grinding wheels seem to stick together and also melt.

Two stars for sandpaper. Death Star for tool parts. I don't often, if ever, get negative feedback. This product annoyed me so much that I have to. Both hints are useless. You have to redo things. The larger one came loose from the part you inserted the screw through within 20 seconds of powering it up. A little tap lasted about 5 minutes before all the velcro wore off and the paper vibrated all around. I just used the pads on my fingers by hand to sand down the fine details.

At first I was pleased to receive and use these Detail Abrasive Pads. The large pad is about 1/4 inch smaller than the DeWalt Sandpad (which I have). A smaller pad is good in theory, doesn't lag. There was a bottleneck with the sanding, used a smaller pad and it worked great for 5 minutes. The sandpaper started to slip off. So tried another piece of sandpaper, took 2 minutes for the sandpaper to come off. The small protrusions at the top of the 1/4" pad are gone :( rendering the sanding pad and

I ordered these to get into hard to reach places and to clean wood upholstery in corners. I first used my Dewalt XR 20v max and the rubber pad started to melt within seconds, no more than between 15 and 30 seconds. I slowed the speed down to low and after 5 minutes the glue on the back of the velcro was melting during use. The velcro flew out of my multi-tool causing the bare underside of the velcro to cut into my woodwork and delaying my ability to sand. If Revain recommends something, I hope…

Photos show wear after FIVE MINUTES of intermittent light grinding. The substrate tears off almost immediately; the Velcro surfaces on the bait melt almost as quickly. The back of the Velcro will soften and smear over the product. It might not have been that bad after 20-30 minutes of non-stop sanding, but it happened (and I tried several approaches) before I could get any work done. . The product LOOKS great right away, but that's the end of the smile. DO NOT BUY THIS ITEM. Of course I can…

Package arrived on time and well packaged. When I opened the product's inner packaging, I was disappointed to find that the sanding pads were not what I expected. They were smaller than the standards I was used to and didn't fit the drivers I had on hand. In fact, I ordered a Dewalt sanding pad with this order and it didn't work with pads that were sent in a separate order. The triangular pads were about 2 inches on each side and everything else I have is 3 1/2 inches so they are not compatible