Review on 🔧 Enhanced Magnetic Platform for Sovol 3D Printer: Upgraded Efficiency and Precision by Julio Montano

There are so many features of printing that you won't know until you start. The print height determines the print time. Flat parts should be printed at an angle or directly onto the plate. Remove supports after cleaning but before curing. This point touches on some of the more painful ones. Have you ever tried building against a slab? It's very similar to trying to get him out of the ball game. Have you ever printed with tightly grouped media? The spatula will never get there unless you let go of the edge. I cracked molds and broke my nails trying to remove molds from the build plate until finally deciding to try this item. I cleaned the build plate completely and then put it under hot water. I dried the board, removed the foil from the magnet, smoothed the edges and pressed the magnet to the board. Then I put the plate magnet on the table and let it rest for a while. Removable plates have two different sides. The side that appears structured should face down. I completed the alignment ritual again and began the tongues out sealing. It failed, which is why the instructions said the tabs are facing me. I tried again and this time it worked for me. The moment of truth was the breaking of the seal. I removed the sheet metal from the magnet and bent it a bit. The print slipped like hot oil in a frying pan. It was the greatest feeling. No warm water, no broken nails and no scraping with a spatula. I washed it off and stuck it back onto the magnet and finally felt like printing direct to the plate was an option and not just what I do when I have no other choice.