Review on AnKun Creality Microporous 3D 🖨️ Printer Bed | Upgraded Size: 235x235x4mm by Demetrius Young

Bought this as an upgrade to my basic Ender 3. It was very easy to install. I just used binding clips to hold it up. A few tips for novice typists like me: Make sure you move the Z-axis switch as this makes leveling the bed much easier and prevents you from scratching your bed like I did on mine. Also, print your first layer with a hotter print bed and higher temperature at the hot end. I've done PLA prints and I do 70*F bed and 205*F end to make sure the print doesn't warp. I expect the coating will wear off over time, but you can flip it over and use a smooth glass side with adhesion like glue stick or hairspray. Much better than a regular bed in general.