Review on Enhance Your 3D Printer with CHPOWER Creality Original Display Ribbon by Russ Mashlan

Arrived today, assembly took about 5 minutes. I have a CR-10V2 which is not on the list of machines but as you can see from my photos it is identical to the one that came with the printer. Rotary knob locks feel a little different and let a lot more through than the predecessor. So if you're adjusting the z-offset during real-time printing, you'll need to check that it's actually moved every time you rotate the click. That's why one of the stars is missing and the other is missing because the new button just wouldn't turn on, the old one clicked into place with no issues but the new one couldn't be convinced. It's just poor quality control. Just like the handles. Installed and ran fine. Installation is simple and uses two connectors. Did. No firmware update required, simply unscrew the 5 screws on the bottom, remove the 2 side ones holding the power supply and lift it out of the way. Then remove the 4 screws holding this board from the front, remove the handle and remove the board. Installation is the reverse order. I'll update this if it fails in the future.