Review on Milescraft 73350003 PocketJig200XJ PocketJig100 PocketJig200 by Marcus Block

Good quality for the price. My first pocket hole attachment. I did a few test holes to see how easy it is to get the correct screw penetration and how accurate it is. The instructions for #200 state that a stop below or fence is used for new work and above for repairs. This is not clear enough as the holes penetrate differently. An upward screw will not penetrate enough and a downward screw will penetrate too close to another surface in a 90° joint, made with #100 and #200 normally have a depth difference of 1-2 mm. I think this is because it is difficult to set the depth gauge accurately. If the exact knots aren't that accurate, I'd like a reference value for all of the depth gauge settings (like you mentioned 111mm for the 1-1/2" setting for #100) to test and facilitate get accustomed to using jigs. - The depth gauge needs to be tight to work properly, you need to learn to tighten it well (be careful not to damage the hex screw). and got a little damaged on the melamine MDF, surface "cracked" different each time. Not a perfect look, but no surprise. - My conclusion is that for 19mm melamine MDF, if I use #200 fence down, 1 - The 1/4" screw tip is 1.5-3mm from the other surface of the second part , so a small mistake in setting the depth gauge or improper attachment can damage the finish. Therefore, I have to be very careful nym and get used to the tool so as not to spoil your work. I think I got what I paid for. The smaller the investment, the more time and effort is required to achieve repeatable, accurate results. I can also confirm that with melamine MDF a pocket hole creates weak joints, many holes are recommended. With solid wood, the connections are strong.