Review on 🏍️ Acelane 2PCS Motorcycle LED Turn Signal Lights: Front Rear Indicators/Blinkers for Motorbikes, Scooters, Cruisers - 12V by Deron Gilliam

Just installed them on my Dual Sport today using a flash relay controller. They seem to be working fine. Let's see how they behave over time. For the front I had to build a small bracket with washers because the factory standard holes were too big for it. The back is much better. I added a lock washer front and rear as well as some Loctite to be sure as others have mentioned issues. I pulled the turn signals carefully and they fit well and shouldn't fly out of the rubber. If they take a good hit they can pop out, but if the wires are ok they can be attached to each other if needed. I had to cut the factory turn signal wire and use a butt joint to connect the turn signals to the stock wires. As with any generic mod, the installation process usually requires some creativity. I bought these because the previous ones broke. I bought them to keep up with the law, but I will mainly be riding this bike off-road. They're not super bright, but they're small. If you want something lighter, get something bigger.