Review on 🔍 Enhance Engraving Precision with SHINA Titanium Carbide Engraving J3 3001Tix10 by Danny Zapata

Machine with 10 engraving bits, tip 0.1mm, cone 30 degrees. I thought these bits would be a good replacement for the ones that came with the car. I was wrong. The first bit I used ripped through the red oak I was engraving. Again I had to use a razor blade to clean the edges. I didn't have this problem with the parts that came with it. I will try some of the other bits in the pack on reclaimed wood. Perhaps these blunt bits can be used to mill the center and then replaced with better ones to finish the edges.