Review on BEAMNOVA Benchtop Drill Press Stand Industrial Kit With 90 Degree Clamp And Tool Holder For Hand Drill Workbenches, Perfect For Repair And DIY Projects by Christopher Holker

I'll start from the good things:1. After adjustment, the drilling press doesn't have play at all (it arrived not adjusted, but it's not a problem).2. The set of adapters enables to mount Dremel tool (at least, Dremel 4300). If I had known this, I would not have spent 69$ on useless Dremel drilling press.3. There are 2 thin plastic strips that enables fine fitting of drill. The mount bracket is a bit larger than 43 mm, and my Bosh drill (43.15 diameter) could not be tightened without the strip.4. The base is massive and flat; it doesn't swing around one of diagonals like Dremel's stand base.5. The drilling press can be modified for milling (there is a lot of stuff on the internet).Cons:1. The column is too short and is bended easily under a moderate pressure (especially when milling) because of its very thin walls. I'll replace it.2. The spring is slightly stretched under the drill weight, even if a drill is not very heavy.Edit:The received drilling press have a few defects, due to which I gave 3 stars. The seller read my feedback, contacted me and offered send replacement parts. I never have met service at such high level, so I change my rating to 5 stars.