Header banner
Revain logoHome Page
Juan Castillo photo
1 Level
745 Review
53 Karma

Review on πŸ› οΈ Creality Original 3D Extruder Assembled: Enhanced Performance with Easy Setup by Juan Castillo

Revainrating 1 out of 5

Works good but not as good

I bought this to replace a hot end 5 part that broke. Overall my experience was positive but I join the stars because the item I received did not match what I had replaced what was advertised. The wires are thinner. The original had thicker wires, 2.0mm OD versus 1.7mm. While this does not affect performance, it is a concern.2. Wires have no terminals. My originals had CNDZ C5 connectors for quick disconnect. The new ones were bare wires that had to be screwed into the motherboard.3. The hose was too short. They included a 13-inch hose, which is about half the size of the Ender 5. It's also too short for the Ender 3 and could have been omitted altogether.

Pros
  • NOZZLE TIP, ALUMINUM HEATER BLOCK, PIPE (TEFLON INTEGRATED)
Cons
  • Not sure