Review on Enhance 3D Printing Efficiency 🖨️ with Creality Original Platform Sticker 235X235Mm by Justin Miller

It was pure bullshit. I liked the print that came with my real Creality Ender 3. However, I wore it down and gouged it out with a scraper to remove the imprint and needed a new one. The first problem, and I admit it was my fault, was that I thought it was 4 packs of real beds. No, it's just a thin paper sticker stuck to a plastic platform. I didn't know this, but honestly it was easy to just peel off the factory decal and then stick one of these onto the factory plastic platform. The sticker is a little smaller than the bed, but it doesn't bother. As soon as you stick it on, you realize that it is not the same material. They are much less grainy and smoother. I knew this would be a problem, and it was. The PLA stuck to it so well it was impossible to remove the print. I get stuck and leave things on the bed. Things have escalated and are stuck even worse. More aggressive scraping caused the bed sticker to tear so quickly that after three prints it was garbage. But it's three packs so lesson learned, remove and throw away then put #2 on.Indidnthat and leveled my bed this time just in case, checked the bed height and saw it was perfectly level. I printed out little things and will not delete them again. A simple scratch this time, and the sticker broke on the first hit. My solution was to go to Laws and buy a 20" x 24" sheet of plain 2mm glass and they cut it to a 9.25" square for free. All in all $11 per door and I now have 4 glass beds that now print everything perfectly. Always stick, easy to remove, very easy to clean.