Enhance 3D Printing Efficiency 🖨️ with Creality Original Platform Sticker 235X235Mm Review

So my original Ender 3 bed had too many dents and it was time to replace it. I picked the cheapest 3 pack I could find on Amazon with premium shipping and crossed my fingers for expecting the worst. But adhesion on these things has been excellent so far. I print with PETG and on a standard PEI surface it took me 70 degrees Celsius to get adequate adhesion and after printing the parts could be removed from the platform by hand. With this surface I print at 40 degrees Celsius and have to use a…

Repeat what others have said. The prints stick to this material like glue. I ignored what the other reviewers said assuming they were doing something wrong since the standard magnetic bed that came with my Ender 5 didn't have these issues and also because I mostly print PLA. God I was wrong! Even with PLA, the print stuck to the surface and was impossible to remove without scraping it with a HARD parts scraper. Eventually the seal was defaced and the bed surface damaged. Solution: USE REMOVE…

It was pure bullshit. I liked the print that came with my real Creality Ender 3. However, I wore it down and gouged it out with a scraper to remove the imprint and needed a new one. The first problem, and I admit it was my fault, was that I thought it was 4 packs of real beds. No, it's just a thin paper sticker stuck to a plastic platform. I didn't know this, but honestly it was easy to just peel off the factory decal and then stick one of these onto the factory plastic platform. The sticker is