Review on 🧱 Efficient RZX Anchor Setting Assortment for Plasterboard Finishes by Noah Lewis

I've only used it a few times but it worked great every time. The included Mollys were fine too. Several reviewers noted that the mechanism requires a lot of effort to pull the trigger. I didn't think so. In fact, I found it much easier to use than my old riveting tool. I have a few tips. 1) After installing the Molly, pull the "Reset" lever to return the mechanism to its original position (see photo). A couple of times it didn't fully reset for me, I had to pull the trigger and then the reset lever again to get it working again. 2) It has a V-groove where you charge Molly. It is designed for both small and large mollies, but a small one can slip into the wider part of the groove. Instead of putting the molly in the hole and then trying to set the tool on the screw, I found it better to put the molly in the setter first. Insert the molly, hold the head of the screw and rotate the body of the molly until it engages the tool. Then put Molly in the hole and start pulling the trigger. My 2 cents. Hope this will be helpful for others.