🧱 Efficient RZX Anchor Setting Assortment for Plasterboard Finishes Review

Tried a few pieces today. The pull mechanism works well but when I try to attach things to the anchors with screws it's a total failure. The thread was gone before you even applied any torque to the screw. It feels like putting a nail in a threaded hole. The screws are so loose that they can be pulled out without effort. You can probably hang a painting on a protruding screw, but there's a chance it will fall off since the screw isn't held in place. If you want to attach something securely to…

Theoretically a great product! ONLY if your drywall is only 1/2" - 1" thick then they are OK. only about 1/4"-1/2" before you reach the part of the anchors with folding arms that presumably bend into a T-anchor behind the wall. After a bad use of the trigger gun I had to pry 1 out of the drywall which created an even bigger hole. I found only 1 arm was broken but again only half! None of the other three arms could collapse. I've even tried longer Molly screws but unfortunately that didn't help…

I've only used it a few times but it worked great every time. The included Mollys were fine too. Several reviewers noted that the mechanism requires a lot of effort to pull the trigger. I didn't think so. In fact, I found it much easier to use than my old riveting tool. I have a few tips. 1) After installing the Molly, pull the "Reset" lever to return the mechanism to its original position (see photo). A couple of times it didn't fully reset for me, I had to pull the trigger and then the reset…