Review on Comllen Single Hole Brushed Nickel Bar Sink Faucet: Sleek Stainless Steel One-Handle Faucet with 360 Degree Swivel for Hot and Cold Outdoor Kitchen Sink by Evan Roberts

So we remodeled our wet bar and used both a Comllen Best Commercial faucet and a Ruvati RVM4136 13" x 15" prep bowl . They work flawlessly together and the deep sink prevents splashing. The key takeaway from this was the shape of the spout in relation to where the tap hole should be drilled in the countertop. We have found that drilling 3-3/4" at the back, as opposed to the usual 1-1/2", provides a near perfect trajectory for the water to get to the center of the sink for our chosen one invade greatness. If you are remodeling an entire sink/faucet/countertop, check the countertop faucet after the sink is installed and before the hole is drilled. So you can customize it perfectly. Added project photo (no backboard - in progress). Another nice thing is that it comes with custom SS cords so you don't have to buy them. They can be connected directly to 3/8" or have adapters for 1/2". Couldn't find any instructions in the box, however. One of the easiest sinks to install. Install the black o-ring under the bracket between the faucet and the column. Clear padding over black padlock with threaded base. Thread on top/handle on bottom. Just make sure you install the two water lines first and screw the shorter end of the hollow tube into the faucet before installing it on the counter. Then connect the water pipes. The color is chosen for practical reasons.