Review on Lisle 45000 Steering Wheel Puller by Richard Turner
"Be sure to remove the steering column adapter! "
I finally got my money's worth! Worked very well on my rebuilt 70's Chevy Van. The bore of my hub adapter shaft was too small. Of course I glued the hub adapter well! It wasn't set deep enough. So I had to take it off. There was no way to remove it without chipping my new paint job. Searched online and found this little "GEM"! Jumped right out! The tool itself is quite heavy! 3/4" thick with thick washers. Bolts were junk! Went in grade 8. Closest points center to center of bolts are 1 1/8" without washers. Comes with shims 1 3/8". Then widest point with 3 shims Glad I waited for this tool! Larry
- Decent performance
- So far so good
New products
Comments (0)
Top products in 👊 Pullers
🔧 Pro-Grade 18212 4" ADJUSTABLE 2 OR 3 JAW GEAR PULLER: Ultimate Versatility for Efficient Gear Removal
9 Review
Fully Assembled CR-V Steel 8-Inch 3-Jaw Gear Puller For Easy Removal Of Gears, Pulleys, Bearings, And Flywheels - DURATECH Gear Puller Tool
25 Review
💪 Get Efficient Hub Removal with OTC (7394) Universal Hub Puller
11 Review
🔧 Astro Pneumatic Tool 78825 25-Piece Master Front Wheel Drive Bearing Puller Set with Grade 8 Drive Bolt
9 Review
