Header banner
Revain logoHome Page
2-pc tap wrench set: 1/16"-1/4" & 1/4"-1/2", perfect for tapping, threading, drilling and lathe work logo

2-Pc Tap Wrench Set: 1/16"-1/4" & 1/4"-1/2", Perfect For Tapping, Threading, Drilling And Lathe Work Review

3

·

Terrible

·

$$
Revainrating 1 out of 5  
Rating 
1.0
🔩 Power Tool Parts & Accessories, 🔧 Power & Hand Tools

View on AmazonView on ЯM

Media

(4)
img 1 attached to 2-Pc Tap Wrench Set: 1/16"-1/4" & 1/4"-1/2", Perfect For Tapping, Threading, Drilling And Lathe Work
img 2 attached to 2-Pc Tap Wrench Set: 1/16"-1/4" & 1/4"-1/2", Perfect For Tapping, Threading, Drilling And Lathe Work
img 3 attached to 2-Pc Tap Wrench Set: 1/16"-1/4" & 1/4"-1/2", Perfect For Tapping, Threading, Drilling And Lathe Work
img 4 attached to 2-Pc Tap Wrench Set: 1/16"-1/4" & 1/4"-1/2", Perfect For Tapping, Threading, Drilling And Lathe Work

Description of 2-Pc Tap Wrench Set: 1/16"-1/4" & 1/4"-1/2", Perfect For Tapping, Threading, Drilling And Lathe Work

Used for threading a drilled hole at a machine location, without actually moving the work piece. Ensures identical center-line of the tap & the drilled hole. Capacity 1/16" to 1/4" ( 1.5 to 6 mm) & 1/4 "to 1/2" (6 to 12 mm). Quick Fast Shipping with a Trackable Awb to USA & worldwide

Reviews

Global ratings 3
  • 5
    0
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    3

Type of review

Revainrating 1 out of 5

Very low quality, mine was unusable

The one I received was complete garbage. The jaws were misaligned and one was protruding out about 1/8 inch further than the other one and no matter how much oiling, cleaning, and finessing I did, I could not make this thing work. Even with a smaller tap (M7) in the end and tightening the jaws down good, the tap was crooked in the holder due to the misaligned jaws. And even with the jaws as tight as I could get them, the tap still wiggled a little bit just from using my fingers to try and rock…

Pros
  • Power & Hand Tools
Cons
  • Incompatibility with Certain Materials

Revainrating 1 out of 5

Not a quality tool in my review

Poorly finished piece of junk. But it is all that is available in this size. Marginally usable. I suppose we will make one ourselves.

Pros
  • good
Cons
  • Locking jaws are mismatched don’t lineup. Poorly designed. Lousy China junk

Revainrating 1 out of 5

Disappointed - Poor Quality, not worth it!

Very poor quality. Was unable to use 1/2” chuck side, would not separate from 1/4” portion. Tap chuck side would not hold tap in center of spindle.

Pros
  • I liked everything except the inner jaws of the chuck are not good for inline accuracy.
Cons
  • Part does look like it’s plated so it will rust easy.