🚦 Enhanced Safety: 2pc 16" 11 Red LED Trailer Light Bar [DOT Compliant] [IP65 Waterproof] [Park/Brake/Turn Signal] - Ideal for 80" Motorcycle Utility Marine Boat Trailers Review

After I covered the bikes on the bike rack, the taillights of my car were no longer visible. I attached these lights to the cover and plugged them into the trailer socket. Now I have taillights!

So I have a total of three of these stylish lights for my trailer. I have two verticals, two of which I am writing this review on the vertical and the other is the only one that is for the brake light. Looks great on my Sharp Bright trailer, very happy with it. Because a modern touch to your trailer compared to the cheap storage boxes that sit on the side of your trailer.

Used to replace a defective center stop light on a pickup truck cover. Very easy. Since the original headlight was in the cover, I drilled a hole in the cover for the wiring and then, after routing the wires, used two self-tapping screws to attach the block to the cover. The transaction was linked to an existing transaction. Very bright, complemented by a base and looks factory. Good thing it's an LED so I don't have to worry about the bulbs burning out.

I ordered these to replace a pair of taillights that were starting to fail on my 2015 Alpine 5th wheel. This is an exact replacement for the existing taillights! Installation was a bit more complicated as I had to solder the wires to the existing wires. Don't worry about the connection since they were the same color. The lights are very bright, in fact noticeably brighter than existing lights. This may be due to the age of the existing headlights, but I'm not sure. The new headlight is shown on

I used them for extra brake lights and turn signals on my truck. They were very easy to install, just find the center where you want the wires to stick out and then you can mark the two screw holes. Once attached to the truck it was easy to follow the markings on the wires to connect them to my turn signals and brake lights. Sun. They also helped reverse my truck at night, which has to do with both their brightness and where I installed them. I would recommend these lights. PS It would be great

They were mounted on a trailer with external brake lights. First time down the hill, with the original lanterns, with 2 bales of hay, and they got caught on branches and bent/broke. Used a grinder to cut the welds and remove the original lights. These lanterns were installed under the gate, which offers exceptional protection. Installation consisted of drilling a few holes and using washers to allow for the necessary clearance for the wiring harness. Grab some blue wire connectors and you'll be

Tail/Brake Lights in our Circle J Horse Trailer App. 14 inches off the ground. If a large vehicle is following him at close range, the brake lights are not visible above his hood. Our trailer had a light bar on the back of the roof but only taillights and it was rusty. away. This 15" Red LED OLS Trailer Light Bar is perfect when a 3 bulb tail light has been installed. Not only does it have a brighter matrix than the taillight panel, as the LED panel creates a very bright brake light by running…

These lights work as advertised. Brake and turn signals, depending on your trailer and/or vehicle type. Forget your trailer/car color code. The main thing to remember is that the white wire on the lamp is grounded. Just ground this wire wherever there is grounded metal. He already has a peephole on the white wire. .Next black wire for H/L switching. The color does not matter. Just find the chain (on some pendants this wire is brown, on some it is green). Next. and very important. no trailers…

Light is a fairly well made unit. I would recommend buying this product. Delivery was quick and well packaged with no damage. Update 09/22/2018: I wanted to give an update on this product. Works without problems since the last check. Also for those who have wiring problems, especially with the "brake" markings. You need to get the brake light source before the turn signal circuit. You can get this source directly from the brake light switch. Usually the best choice is a brake light circuit with