AmazonBasics AB BDH111 Adjustable 2 Pieces Two Pack Review

I think they should be in every curtain set, not the pointless ones that require you to poke holes in the bottom. Also, it keeps your door level better than a small notch on the bottom. I took the 2x6 and pushed it down (mounted on a baseboard in a carpeted room) to make sure I got it to the right depth. The only improvement I saw was when you had to adjust the internal screw further towards the wall. This wasn't a problem for me but just make sure you have thicker baseboards than usual to test

A must for barn doors. I put up a partial wall and installed one in my master bath to be able to retain heat when using the wall heater. I didn't have room for a traditional opening or opening door. It was my first barn door so I didn't know the damn thing would swing unless it was secured underneath. They solved this problem and solved it well. They are very easy to install and the equipment itself is well assembled. They keep my door in line well. The door just slides through them. You can…

I bought these tracks for some of the barn doors I have in my attic as the ones I have currently are plastic and keep falling apart causing the doors to open to let. from the wall. Unfortunately I can't use them myself as they are very metal and have fairly large rollers on them which means that: 1.) The rear roller (the one closer to the wall) pushes the door too far away from the wall, causing a creates a large gap between the wall and the bottom of the door, and 2.) the length of these rails

Great set of door tracks for barn doors. We installed a $400 Lowes barn door that came with excellent top hard plastic bottom tracks that were barely visible. Due to the way my door is configured, I had to use the included wall mounted plastic track along with the included floor track to keep my door guided at all times and unable to rotate freely. It was an odd, jerky setup, and it looked bad on top of that. These two tracks match the expensive black metal of the expensive hardware at the top…