🔊 1” Car Audio Tweeter Speaker - 3.25” Bullet Horn Aluminum Die-Cast Titanium Dome, 300 Watt Peak Power, 2k-25kHz Frequency Response, 4 to 8 Ohm Impedance, Heavy Duty 20 oz. Magnet Structure - 1 Pair - Pyramid TW18BK Review

Get what you pay for what I expected but the answer is missing. A real can, and difficult to set up. I don't think the frequency response is as wide as advertised but definitely more than a standard tweeter. They brought them into stacked plywood rings and now into 3D printed cases. You can achieve up to 75W RMS on a quad amp connected in mains mode at 80 PRS with 3-way active crossovers.

There is nothing better. I took a chance and replaced the tweeters in my JBL 4406 monitors with these cheap tweeters because their sensitivity matched - this is an important factor when replacing tweeters with another brand. Wasn't expecting much and just wanted to use them until the diaphragms came to fix my bad tweeters but I'm leaving them installed. Crystal clear highs and they handle more power than my other tweeters. Good value for money.

Restoration of the interior of my 1970 El Camino. When I removed the dash I found 2 tweeters I didn't know about. After I found them bad, I ordered them from Revain. This is the Pyramid brand that totally blew my mind when I opened the package. I had no idea the pyramid still existed. In high school we bought Pyramid speakers for our cars at a local exchange. Because they had a smaller budget, they failed, and then we just got more on the exchange. I'm happy with their sound and grateful for…

Works very well, better than the tweeter to be replaced in an expensive Onkyo 4-way floorstanding speaker (8 ohms, 150 watts). The original super tweeter in the right tower failed and I replaced it first to compare to the original Onkyo super tweeter still working in the left tower. The pyramid definitely stood out compared to the original in the other tower, so I went ahead and replaced that as well. I had to drill a bit more hole so I decided not to do it unless there was a noticeable…

I'm not clear 4 ohm separate tweeter or 8 ohm. It says 4/8 ohms, which to our knowledge could mean 4 divided by 8. As many have written, the sound is very sharp. This may be because this is an efficient speaker and I would assume that if it were a 4 ohm speaker it would severely overload the woofer and/or mids. The correct way to dampen this tweeter is to use an L-shaped spacer. An L-shaped pad is a simple circuit made up of two resistors. There are websites that will help with that if we only…

Phenomenal tweeters. They are bright, loud and big! I don't think I'll ever go back to a 1 inch speaker. I installed them on a 1998 Chevrolet K1500 pickup originally hoping to put them in the standard tweeter position but due to the size of these tweeters I was unable to fit them. I improvised and placed them just below the door and window controls. Approximately 3.5" to the right and 3.5" up. Check my customer photo for the exact image. I use the crossover tweeters that came with my PPI 6.5…