Beduan Pneumatic SAEJ844 Tubing Transfer Review

Nowhere on this tube is it stated that it meets the SAEJ844 standard and is therefore DOT approved. It fails the DOT test.

Works well. The only problem is that they sent me an 8mm hose instead of 3/8 and found out about it too late. Already installed on the vehicle and took the time to order 3/8 tube fittings.

I used this pipe to replace the breather hose in my Humvee. It's not exactly to spec as I had to shave it off to get the 1/2 ports to work. Also, I know the inside dimensions are a bit smaller. This will work for your project, but you'll need to heat it up, sand it down, and shave it to get it to fit.

I had an old compressor that needed a new regulator and the sensor wire was dry and cracked so I replaced it with this product. It came with lots of repair leads for what I needed it for. I was blown away by the box it came in, better packaged than many of the electronic parts I received.