🔥 Enhance 3D Printing Performance with BIGTREETECH TMC2209 Heatsink Stepstick Review

Wow these guys work way better than any TMC on IE 2130 or 2208 and they have all the features of the 2130 but over UART like the 2208. They are connected SKR1 .3 and they work perfectly, no ugly cables to chain them to the motherboard. In the end I cut off the top contacts and glued on the Kapton tape to protect the heatsink from a short circuit. until I worked. Overheating in Marlin and I'm running my 2A motors at RMS1600 @ 24V and just a tiny noctua 40x40x20 5V fan blowing on average…

I bought these drivers to replace the stock A4988 that came with my printer. Unfortunately, these standard drivers are quite loud and not very pleasant due to the screeching. At first I had an issue with one of the drivers being faulty, but Bigtreetech sent a new one and I got that one and others right away. They come with good heatsinks and are very easy to install. I set the voltage to around 1V for the X/Y/Z axis and 1.2V for the extruder. Now the printer is very quiet and when I'm not…

Bought to replace the TMC2100, they work fine. No more missed steps due to motor overheating. They send power to my stepper motors and allow me to fine-tune how much power is fed to them via a menu in my printer's menu. Now I use almost three times less energy for my motors, which makes them cold even at high speed. That means no more missed steps due to overheating. This also means that my printer is significantly quieter. They also provide enough power for my extruder motor to pull in @ 80mm…