BUD Industries JB 3959 KO Junction Knockout Review

Pictures are very deceptive, no keyhole or flip plate. Just remove the cover. Still durable but not what I thought I ordered

Product is incorrectly advertised with a photo of a hinged lid. The misleading photo has resulted in a waste of my time and effort.

I should have read the reviews more carefully because already two people mention this problem. The picture shows a box with a lockable door. This does not apply to this product.

1 star given to draw attention to the wrong picture. Lid cannot be opened. This is a standard flat plate with holes in the four corners. The model number in the description is correct.

Junction box is perfect for the project I was working on. I just added a back plate to attach and pre-wire my components before mounting the plate in the box. Many Thanks.

Well, it's my fault that I'm looking at the picture and just looking at the measurements and not reading the whole description. No lock or flip cover!

Well it's my fault for going by the picture and just looking at the dimensions and not reading the full description. No lock or flip cover!

20 more words required The picture shows the front of the lock. The box I received didn't have a lockable front door, just two screws. battery and switch?

This box is installed next to a load center I just installed flush to power my garage workshop. All wiring is surface mount, so I needed a way to route all cables "outside" the wall, into the wall, and into the load center. So I need a 6" deep junction box; about 4" of it could be inside the wall (so wires can be routed to the load center) and the remaining 2" would be sticking out on the outside of the wall where all the EMTs go through surface mount conduits This box was perfect, it allowed…