🌈 100ft C-able RGB Wire Extension Cable with Spool - 22 AWG 4Pin for 5050 3528 LED Lights Strip, Includes 8PCS RGB LED Strip Connectors Review

Fits my needs very well. I found the ports difficult to use. I had a hard time soldering that close to the other terminals without shorting them out. The wire was well made and worth the purchase

The jacket on these wires has worn through most of my connectors. Or the plugs don't work. In any case, I have found that the variety of LED lighting is so varied that it is difficult to use. The wire is generally good but maybe better suited for soldering.

I bought this to expand my soil moisture sensors on my Arduino Nano board. I only needed 3 of the 4 leads, but I left the 4th connected in case I needed it. I crimped the ends to attach them to the nano as well as some quick connects for the sensor.

The cable is not flexible, difficult to bend or twist, also its coil is very thin, it is very difficult to strip wires. The connector is not soldered, it is impossible to connect a wire to these connectors without a solder kit, so it is very difficult to use it as an RGB cable extension.

If you are looking for an affordable RGB cable for automotive or marine wiring, then this is it. I recently purchased Kicker KM65 marine speakers to fit my Jeep, these cables are perfect for that. 10/10 value for money compared to Kickers RGB wiring. Save money and buy this wire.

Well the wire works fine. Clips work too. However, they do not work together. So if you want to solder your strips or use clips to join two strips together they will work individually but you can't use clips to join the wire which you might assume since they are packaged. .

If you do housework, it works. Some people just can't think outside the box. If you buy this cable, in most cases you will work with my RGB LEDs. yes you have something to do Yes, you will have to do a little soldering if you use it to connect lights so there is no light where you don't need it. When I'm done I'll post a photo. I need to find some time to finish work. You'll need to solder the connectors on both ends if you're trying to keep the light in one area.

I initially bought this set thinking I could use the cable and clips to extend my existing LED lights. Unfortunately, wire is used specifically for solder connections, and connectors are used for solderless connections. I don't know why it's a bundle as the cable and plugs can't be used together. If you want to use plugs, you need a different cable, and if you want to use a cable, you need to use different plugs. I'm trying to solder the wires to the contacts. DO NOT DO THAT! This melts the…

The wire is great and easy to work with. Clamps are perfect for connecting two strips of 10mm LEDs, for example if you accidentally cut a strip in the wrong place because you don't have to measure it again - you'll remember where to cut it and if your wife tells you to You cut in the wrong place, what does she know? You've got an engineering degree and women are notoriously bad at metrics, so SNIP URGENT! *sigh* But hey, these clips are great for attaching a LED strip. In my case, a sincere…