🔌 CCiYu 6-Pack White T4/T4.2 Neo Wedge 3014 SMD A/C Climate Control LED Light Bulb Instrument Gauge Cluster Indicator Lightbulb Review

They are bright and had no trouble installing. Only a month later they started flickering and after 4 months these bulbs had to be replaced twice. I ended up going back to the original OEM bulbs.

Poor quality. The diameter of the LED is larger than the standard T4/T4.2, which is why the bulbs do not fit into the standard socket. waste of time and money. Had to order from another supplier to get T4 LEDs that fit properly.

Fits my 2004 Jeep TJ as described. They were the same bulbs except the LED strip didn't fit my AC panel outlet. I had to ream the hole a bit to make it bigger. Then they fit and work well.

Doesn't match my 2004 Pontiac Vibe. To install these lights you need to push the LEDs through a small hole, then place a screwdriver behind the light and turn it a quarter to lock it in place. Unfortunately, the white disc with the LEDs is larger than the hole. The hard drive is big enough that I have a hard time imagining it working with any setup, not just my particular machine.

Very disappointing. I bought a dash light for my 2009 Toyota Tacoma HVAC. The LED assembly is too large in diameter to fit on the circuit board. I'm imaginative so I took a Dremel tool and carved out the base of the LED assembly (the white part under the rectangular LEDs) and was able to mount them but they didn't light up. Low quality!

Not good. The PCB holes for H3 need to be enlarged. LEDs are on. The yellow indicators in the dials are off. Air conditioning, internal air recirculation and heated rear window do not work. After a few minutes, all three internal amber lights will flash a few times and smoke will begin to emanate from your control module as it cooks. $214 new. Beware of them. Revane is listed as working on H3.

I bought this for my 2003 Toyota Tacoma. They weren't suitable for my application as the LED base was too big to fit in the factory holes. The company offered me a full refund and emailed me to make sure I was happy. The product has its flaws and they have assured me that they are working with the manufacturer to resolve this issue. Excellent customer service. A+

Most of them weren't installed properly and therefore didn't work. The very thin and thin wires on each side need to match the socket to make a connection for power transmission. The cords on some of my lamps were miswired so when I plugged them into outlets the cords snapped or deformed rendering the lamp unusable. The headlights cost the same to return as they did to buy, which is why they ended up in the trash.

Like the previous ones, I also bought from another seller, the quality of the mounting plastic was lousy. Although my Tacoma truck is listed here as a good fit, the LED was too big to fit through the hole. After installing the Prior from another seller, here I not only knocked out the fuse but somehow damaged the wiring, then I threw my hands up and redid the LED head on top of it to fit the hole that the Wiring and the resistor glued the base with hot glue, pulled out the wires, wrapped around