🌙 2-Pack LED Night Light Lamp Base with Remote Control, Acrylic Blanks, Charger Cable, and Adjustable 7-Color Lights Base Review

Excellent flashlights. but. Don't lose the remote or they don't have many manual modes. And they activate when we use our DirecTV remotes near them. They immediately go into rotating flashing mode. Pooh.

A great gift for our Minister of Music. I had to buy blanks from another store because the one that came with it was too thick to go through my Cricut Maker. I wish the dimmer was lower. I plan to try something else with the attached form.

I ordered 2 packs and they arrived quickly. Gave it to a friend and she absolutely loved it. I will be ordering more for gifts in the future. I had questions and the customer service was amazing. They responded to emails quickly and were very friendly. The supplied acrylic blank is too thick for the Cricut marker.

I use them to display 4 inch round acrylic gift discs. I've noticed that they turn themselves on when I hit them, which doesn't stop me from just using the remote and turning them back on. I think if you haven't noticed you could be using a lot of batteries. I love the fact that you can also change the colors that are displayed.

Good base, good price. Remember that it comes with an acrylic blank only. The slot has a couple of clips molded into its bottom so it can probably hold acrylic sheets up to about 3mm or so (it works well with sheets cut from 3.6mm sheet metal). (Note that some sheets sold here that are advertised as 4mm are actually around 3.6mm thick.)

I was pleased with the two stands as they work as expected however they did not come with acrylic parts as shown in the seller's photos. and if you read the description and see what's included, it clearly states that acrylic is included. then below it says acrylic is not included. I've highlighted both to show them. So other sellers give acrylic if they don't I won't buy from them again. Look at the picture and ask if it works or not, I didn't succeed.

Almost exactly what I need. I had to improvise! First I found a base with a connector on the side, not the back. I then cut it almost in half with a miter saw, being careful not to cut the motherboard. I couldn't find a rectangular base and needed it to fit on a 3 1/2 inch shelf for my project. Now it fits and works perfectly! The lights are good bay! I removed the battery compartment. Sometimes you have to think outside the box. Perhaps the company could also make a rectangular base.

Bought a pair of these, one broke right out of the box. Others could not be controlled via the remote control, but only manually. Oddly enough, the power cord goes into the SIDE of this base rather than the back, so the cord and plug aren't visible. Be that as it may, when connected, the USB cable and its acrylic insert are clearly visible. The only sillier place to put it would be right in front of it! Due to the fact that more than 50% of what was received failed, it went back. I would look…