Header banner
Revain logoHome Page
πŸ”₯ everflow 600c034 nl forged solder supplies logo

πŸ”₯ Everflow 600C034 NL Forged Solder Supplies Review

3

Β·

Poor

Revainrating 2 out of 5Β Β 
RatingΒ 
2.0
πŸ”§ Fittings, 🚰 Hydraulics, Pneumatics & Plumbing

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”₯ Everflow 600C034 NL Forged Solder Supplies
img 2 attached to πŸ”₯ Everflow 600C034 NL Forged Solder Supplies
img 3 attached to πŸ”₯ Everflow 600C034 NL Forged Solder Supplies
img 4 attached to πŸ”₯ Everflow 600C034 NL Forged Solder Supplies

Description of πŸ”₯ Everflow 600C034 NL Forged Solder Supplies

Everflow part Number 600C034-NL. Lead free full port ball valve. Forged Brass construction with Chrome Plated Brass ball. With 3/4 inch solder cups for use with Copper pipes. Upc approved lead free product for 150 psi steam and 600 psi wog.

Reviews

Global ratings 3
  • 5
    0
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    2

Type of review

Revainrating 4 out of 5

Great offer. good fit for fittings

So it seems as good as any to me. Solder them properly, don't overheat them, and none of mine leaked or needed packaging adjustments. Great value compared to local ones in my opinion. YMMV.

Pros
  • Lead free full bore ball valve
Cons
  • I'll write later

Revainrating 1 out of 5

Not suitable for 3/4 inch copper pipe

These valves are junk and I doubt the validity of their shown performance based on my experience with three of them. 2 hours north of my camp's water main zip code. It takes an inordinate amount of time to wear down the end of the pipe to fit one of the valve braze cups, and the packing nuts had to be tightened once the water was turned on. For a really high-quality product, I would personally spend a few euros more.

Pros
  • Forged brass construction with chrome plated brass ball
Cons
  • Not sure

Revainrating 1 out of 5

You get what you pay for.

I bought 5 of these. Saved about 30% off the price at local big department stores that sell cheap same quality valves. 3 out of 5 leaked the valve stems but I managed to tighten the gland and stop the leak. After 24 hours 1 of the ones I had tightened started leaking again but I was able to re-tighten to stop it. Let's see how they look tomorrow. I wish I could pay double the price for some of the big brands quality valves and if they start leaking again I might have to do it anyway. It's not…

Pros
  • 3/4" brazed for use with copper tubing
Cons
  • Not bad but...