🔦 GETINLIGHT 3 Color Dimmable LED Under Cabinet Lighting - ETL Listed, 2700K-3000K-4000K, 24-inch, White Finished (IN-0210-3) Review

I like the fact that it's easy to assemble without disassembly (2 screws go through the entire fully assembled unit) and it plugs right in and mounts almost flush with the back of the wall. In addition, the light is nicely diffused – you don't see the individual LED cells. The exterior build quality is also good, with no rough edges or color runs. I also like the fact that the hole on the back for direct wiring is in the middle of the unit so you can pre-wire it on the wall so the cord comes…

This product has the advantage of being easy to install, requiring only two screws. However, this simplicity comes at a high cost and low light output. While the device can display three different color temperatures, which might make it easier to market, I only wanted 2700K and I suspect most people will pick one color and stop there. Each unit has an integrated power supply for easy installation, and multiple units can be daisy-chained with different lengths of connecting cable. While a…

Bracket looks good. Works as it's supposed to, BUT it's not designed to connect. Essentially, you have to plug it into an outlet or into a nearby light fixture. That would be bad enough, but it gets worse. The box has plenty of 'knock out' holes for passing house wiring through the wall of the light and comes with a conduit connector. But knockouts are fake! With fake little welds to trick the eye. You are very likely to deform and damage the fine-pitch bracket when you try to pull it out. They

I installed this over the sink in my vacation rental as there is only overhead light and I wanted more light while washing dishes. I also like the ability to leave a softly dimmed light in the evenings. I bought an 18" flashlight and it fits perfectly. As mentioned the screws are too long so if you mount it under the case they go through the bottom of the case. To solve this problem I used one piece thin wood I hid when I installed the cabinets. I believe it was an extra piece of baffle plate…

Very easy installation Two screws that mount vertically through the unit. It was so easy - it's a 24" model so it had to fit 32" (32 - 24 = 8 and 8/2 = 4) so measured just 4" from the edge and it was perfectly centered. over my sink. Then simply screw in the screws manually to secure and fix it. I chose to connect the unit with a power cord that plugs into an outlet above my microwave. I was able to route the wiring just by drilling a vertical hole above my cabinet above my microwave and…

I bought one of these because it could be wired to turn out some of the fluorescent lights under the kitchen cabinet. I bought one to try first. There's no point in buying everything first - just in case I need to return them. Based on the installation I did, the advantages of this light: * The lantern looks very nice and thin. * many knockout holes - suitable for almost every power supply. * easy testing - just take it out of the box and use the included power cord * quick connector for wiring