🖨️ Enhance Printer Performance with HICTOP Z Axis Upgrade Stepper Printer Review

I installed this on an Ender 3 Max - you have to remove the PSU for this or it interferes (I just benched the PSU at the back of the printer - it works fine.) On the Max, the threaded rod extends an inch or two past the end of the top rail, but I didn't see fit cutting it off. The included "instructions" consists of a horrible YouTube video where the camera shakes, the steps are fuzzy, and some parts don't match the equipment that came with it. However, I finally found out. An important step…

This kit was installed just a few days ago. The metal parts feel well made and look like original Creality parts. After leveling the gantry and re-leveling the bed, everything will be fine. I installed the Ender Extender 400 (X&Y) kit. The gantry sag was quite significant after I installed the extension, this dual z kit eliminated the sag completely. Now everything is in order. My complaints are only related to upgrading my printer. This kit comes with a Z motor splitter cable, allowing you to…

I have an extra heavy tool on my Ender 3 Pro. Unfortunately, when using only a Z stepper motor, the right side of the X-axis guide sags a bit because nothing is holding it. This becomes even more apparent when the hot end moves to the right of the x-axis. I tried everything to see if I could stop the streaks that were showing up in my printouts. I finally bit the bullet and tried this double Z kit. It was amazingly packaged, with tons of extra screws and bolts. Installation was a bit tricky as…