🔧 Housolution Aluminum Woodworking Welding Adjustable: Enhancing Precision and Versatility Review

It takes a bit of fiddling to line up the two sides, but one of them holds the pieces in place. I bought it to build boxes and it's amazing for that.

Not the best fitment. It looks like it was made by a toy manufacturer. The screw shank is rough and does not interact well with the internal threads. cheap stuff

I've had a lot of 90 degree angles on these book towers I made for Christmas and this thing worked great. I used this clip to hold my corner and a few more to hold my pieces together tightly when hammering nails - it doesn't get smoother than this.

Bought to help assemble the box. The clamps hold as advertised but since the handles are on the inside they can and will conflict with each other. Again, they work as advertised, but the 12x10-inch box just doesn't have enough space for pens.

emphasis on the left side when you're not looking down at 90 degrees. It's about 3 degrees from square, and you can't close the connection unless you move the clamp, which is ridiculous. The finish was good, but it was just a bad cast. didn't feel like you could put too much pressure on the joint to avoid breaking something. not a good buy

Brackets are nowhere near square. The "walls" that hold the wood taper outward at the top, leaving a large gap at the angle joint when you clamp the two pieces together. I am 100% sure that these are not my cuts, they are clamps. Returned and purchased bessey brand angle clamps (red clamp in picture) for a cheaper price and they are much more accurate. Not worth buying, except maybe for rough construction projects. may be.

Got a dozen of these to complete my built in bookcase project in our new home. I needed something that would hold the 3/4 stock nice and square along the top/bottom and front/back of the bookshelves. These are solid aluminum pieces with a good powder coat finish and a large rubber button for tightening. I believe they will last until the center pivot fails, which should take quite a while. The disadvantage of these clamps is that they do NOT straighten your work piece. In fact, they can move…

I only give this product 4 stars because it is exactly the same as at least one other that costs $5 less. Performance and price compared to other products probably made in the same factory but sold under a different brand here on Revain, still 5 stars. The photos show this product and another that is $5 less. ACCURACY / PRECISION: I used my Milwaukee aluminum square and Husky digital caliper to check squareness and thickness uniformity. I've tested the square and caliper on editing tools and in