🏠 Hy-Ko Products FM-6/0 Floating House Number 0 - 6" High, Black - Premium Quality 1 Piece for Clear Address Recognition Review

Love these numbers! They did a great job on the exterior of our home. Several neighbors asked where I bought them. They also bought rooms on Revain for their homes.

These numbers look great and are very easy to install. No need to use a template to find screw holes. Just slide the pins into place, set the number and tap lightly with a hammer. Then the places for the screws are marked. I definitely recommend these rooms.

Just bought a mid-century ranch with fancy 80's style wooden house numbers. A simple house number change and front door hardware upgrade refreshed our front door. The rooms are elegant and strong. The template makes them so easy to align. I love her!

Bought four digits. For some reason "zero" has a defect. The threaded holes in the digit are smaller than the included mounting screws and smaller than the holes in the other digits. So I'll either find smaller screws in the garage, or I'll try to drill larger holes. Both solutions should not be necessary. Zero is zero!

I'm a handy person so I'm good with it and it's not that hard but it's not something most people have dealt with before and none of the rooms I have not received any instructions. In any case, it doesn't really matter as other reviewers have mentioned that the instructions they received were poor. 1/5 stars. Too expensive not to be a one stop product including installation guide and process.

The numbers themselves look great. However, I found it difficult to attach numbers to my column. I followed the directions and drilled a 3/16" diameter hole. I had to increase the size of the holes to insert the anchors. I inserted the anchors, took a rubber mallet, and when you start pounding in numbers, break the anchors. Half of the number is fixed, the other half just hangs. Good luck finding replacement clear or white anchors. Fingers crossed the gorilla's glue holds up. Like I said, the…

. * Clean, modern design. THE BAD (I noticed this and many other reviewers noticed it too): * 0 (zero) doesn't have the same font size and weight (thickness) as the rest of the numbers in this series * Plastic inserts are junk. They break very easily. Be prepared to use your own plastic anchors as you will not receive any additional plastic inserts in the packaging. * The instructions are obviously wrong. The instructions say to use a 3/16 drill bit, but it's too small. You need 15/64 when…

Well, here it is again. Yes, they appear to be metal, but they're actually just junk. And it's not SIX INCHES. They ranged from up to half an inch, from 6 1/8 inches (1) to 5 5/8 inches (5), with three others in between. And the width of the outlined metal is also different in size. It looks like something invented by a careless second grader. And when they do need repainting, they're covered in some sort of plastic coating that the paint doesn't seem to match well with. do they cost 10 euros…

Bought a craftsman style home set. I really love them, but as some other reviewers have said, 0 is actually smaller than other numbers. I'm grateful that the 0 in my house number is in the middle, so it doesn't look terrible, but the numbers are all different heights. I haven't used anchors and they seem very strong without them. It's actually pretty easy to set up once you've done the first number. I did the pre-drilling with the supplied sheet of paper. I then screwed the threaded side of the