🔧 Luckyway 5-Piece Twist Socket Set: Premium Lug Nut Remover Tool Kit for Metric Bolts & Lug Nuts Extraction Review

Wasn't the right size but I was able to grind the bolt head and it fit. Then, after hitting, the broken bolt came out. The socket saved me from many disappointments

Works very well. Nuts were ripped off and tightened by a service center. They were good enough to round out most of the nuts. I've spent hours trying to remove them with no success. This article delivered them in no time. Fast shipping and item works as advertised. Very happy.

Very high quality. Unfortunately it didn't fit the shackle locks which I was trying to remove. The 21mm lock fitted closely to my VW lock but not tight enough to remove. Eventually the nest weakened and lost its grip on the overstretched nose. I couldn't even unscrew the properly tightened locking bolt. According to the plan"C". ha ha. I still have the tool and I'm glad I bought it.

Some of the OEM nuts on my son's car over the last year have "swollen" and become harder to remove (they no longer fit the 19mm socket ). I ordered this set as there was a pair I couldn't take off without risking taking them apart. They worked great removing the bad studs and I replaced the OEM nuts with a new set.

Stuck Nut, broke 1/2" breaker by removing it. Tried a few other things but to no avail. Otherwise I would have taken it. I've used the nut 5-6 times marked before attempting to snap them off. 1 time didn't work (I don't seem to weigh for that nut). Flipped breaker bar for lifting and added a 2" pipe to help. It popped up right away! The Damage to the clamp nut was significant but I didn't care The damage to the socket itself looks like it only removed some of the black coating on female threads

Bought a cheap car from A to B, seller said he didn't have time to replace the O2 sensor on the manifold. Upon further investigation, it was found that the top of the O2 sensor was broken and part of the nut was rounded. The 21mm socket is deep enough to fit around the O2 sensors and thin enough to let the heat shield through. Just a couple of presses with my 1/2 stroke successfully removed the O2 sensor without breaking the filament.

I broke a stuck nut and 1/2 inch breaker after removing it. Tried a few other things but to no avail. or I would take it. I marked the bushing on the nut 5-6 times before attempting to break it. 1st time it didn't work (I probably don't weigh enough for this nut). for lifting and added a 2ft pipe to help. It showed up right away! The damage to the clamp nut was significant, but I didn't care. The damage to the socket itself looks like it just removed some of the black coating on the internal…

After a little experiment, I removed the locknuts from my Chevy Malibu. The key to the nut was lost, so I had to unscrew the nuts without a key. There were no instructions, but I watched several YouTube videos demonstrating similar tools. Using a 20-ounce hammer to tighten the bushing on the lug nuts did not work. When I put my long handle on it, the jack slipped off the nut. Solution, get a bigger hammer. I have some hammers but they were a few hours away. I had a 6lb sledgehammer, too big I…