🪚 Norske Tools NCSBP272 8-1/4 inch 60T Melamine Plus Saw Blade: Ultra-smooth Cutting for Melamine, Laminates, Hardwoods, Laminate Flooring. 5/8 inch Bore with Diamond Knockout Review

When it comes to installing laminate flooring, it's important to find the right blade to cut with. I'm happy with how it works.

I used to install laminate floors but always used a regular saw blade. The fine dust was unbearable. The dust generated by this blade was minimal and stayed sharp throughout the project. The cuts were accurate, there were no chips. I would recommend this disc to anyone laying laminate.

Blade performs well. I used it for melamine and the blade had very few chips on the top and small chips on the bottom. I haven't found a blade that won't chip on the ground without a scoring blade, but this blade is no worse than the more expensive blades I've used. Recommended as blade of first choice. Great value for money.

I have been using melamine sheets in my shop for over 30 years. Thought to try this. Bad choose. It splintered melamine-coated chipboard much worse than a standard cross disk. I always get small chips but it looked like a serrated knife. And it was fresh out of the box, never used. Don't waste money. This blade is a joke.

I used this disc to cut 14mm laminate for a floor renovation project in our house. The blade was easy to install, although you have to be careful as the edges of the blade are very sharp. It cut through the laminate precisely and efficiently, and the only failed cuts were due to operator error - call it a learning experience. Very happy with blade performance so far and I'll update the post if I find less than optimal wear. I have three more medium-sized rooms to set up, plus a hallway, and…