🪚 Graff Speedcutter 4 1/2: Premium Wood Carving Disc for Angle Grinder - Circular Saw Blade for Precise Cutting, Sculpting & Shaping - 7/8" Arbor - 115mm Diameter Review

Accidentally bought 5 inches. Needless to say, it fit in the protective case of my 4.5 inch grinder in Milwaukee. I tested it, it rotated without intervention. Well as soon as I gave it full throttle it started, an arc of sparks flew about 6 feet up. Two of the three blades are fired at Mach 10. One went straight down a hard wooden staircase 15 feet to my left, the other got stuck in the ceiling and went just an inch past my face. I wore goggles. Make sure you choose the right size or run…

I had to cut some long grooves along the inside roofline of my log cabin to install new ceiling tiles. I used to use a chainsaw for things like this, but following straight lines this way is a real challenge. Imagine an angle grinder fitted with my new GRAFF Speedcutter blade. At first I tried to follow my lines by pushing the boat forward, but it just didn't work; The instrument was everywhere. But when I changed tactics and tried to "pull" the grinder along the line, it was the ticket. It cut

Yes it's a great tool, it certainly cuts and slices wood like butter but. Because it's so incredibly easy to use, it gives a false sense of security, a false sense of "I'm in control" until I've used it to shape the flooring around the door frames. tool in the right place. Most of you get what I mean. So I held the board instead. let him, but with extreme caution. Actually I was hesitant to let him, he was a fast guy. He liked it straight away, then he started teasing me about having cool…

I bought this disc to trim a stump I felled a few years ago; I try to cut the stumps short enough so they don't get in the way of the lawnmowers, but this case was tricky; it was on a slightly sloping piece of land and one side was too high; I could mow it, but my neighbor seems to use a lower height setting and "cut" it from time to time. They can costly damage a lawn tractor, so I used this knife to trim it down to a level closer to the ground. I wasn't sure if the blade would work…

This monster gets the job done like it does now! I process oak for artwork. Before I knew it I was cutting holes in wood and hollowing them out. Not correct. Then I started using a 7 inch free hand circular saw which is very interesting and effective. People stay out of your way. The carpenter then recommended this tool to me. Thank you! This wheel runs as fast as a circular saw and cuts by hand more cleanly. Also, a 7-amp grinder doesn't twitch much with this wheel and threatens to slice your…