🔍 SEO Optimized: POWERTEC 6" HSS Jointer Knives Replacement for Delta 37-658 37-190 37-195 37-205 37-220 37-275X, JET 708457K JJ-6CS - Set of 3 Review

I got an old Delta Jointer from. must be 70s. The blades were rusted quite a bit and could certainly use a sharpening, but the surfaces were a bit uneven and for $15 these new blades were perfectly flat. My jointer skips tons of material with no problem. Definitely exceeds expectations for the price. However, if your blades are a bit rusty or dull but still perfectly flat, try sharpening them first. Depending on your planer, especially when using this type of blade, aligning new blades on the…

They also fit the old Delta 37-280. Very good two beveled edges, absolutely faithful, beautifully cut. I was concerned that these blades were 1/32 thinner given the nasty 37-280 blade clamp pattern. Fortunately, this is normal. I have nothing to say about the Delta 37-280; With a flexible guard, no output table adjustment, no blade lifter, and a poorly designed and manufactured clamp that tends to misalign the blades, I plan to spend at least 2 hours of misery adjusting the blades with a…

I bought 148030 HSS blade for my Delta 37-190. Then I saw that 148031 was cheaper and bought them too just in case.I took out the old triangular blades and was about to install 148030 when I noticed the concavity of the new blades so I returned them.I also received 148031 and the flatness of those blades checked and the two sets I bought were concave I ordered a new set 148030 and they lay flat on the bed and I installed them and they work fine I don't know what the difference is between 148030

I replaced the old dull blades with these. I set them up perfectly and attached them to my 6 inch Delta planer. Unfortunately, after a few passes, I noticed that the wood I was routing had raised lines. Started with a prominent line, then several more became visible. when you look at the blades, each blade has a few nicks, i haven't been using these blades for long, kid, the old blades i had gave me a perfectly even cut, but over time they dulled (for a long time time) . These Powertec blades…

My machine's blades are overdue for sharpening. I forgot to sharpen my second set. I bought these POWERTEC blades so I wouldn't stop there while both sets of my Delta blades are sharpening. Installed these POWERTEC blades, ran some test patterns. Compared to my dull blades, these POWERTECs cut hot butter like a knife. The chips were full, the effort required to push the workpiece onto the table was minimal. I noticed that the cut was at an angle across the width of the board. I checked the…