⚡ Proster 12pcs Multimeter Test Lead Kit with Replaceable Alligator Clips - Automotive Extension Clamp Meter Leads for Electronic Multimeter Testing Review

They are perfect for my 87 meter fluke. Plus, you can turn them into awesome jumpers with a gauge plug-in and matching test lead tips.

The wires are well made and I like that one end is L shaped which makes it easy to use and I appreciate the different tips especially the longer probes which can remove the plastic probes screens to get into deep places.

This makes the meter very economical. Orthogonal sensors were too large to measure most modern electronic circuits. These are very sharp probes so be careful they are easy to poke!

Pin size test leads did not match the probes. Ask yourself how you can use them. The description is completely inaccurate. I bought them specifically for needle probes. But I just can't use cables. For me it's a waste of money.

Haven't used them extensively, but so far they're doing exactly what I need. I mainly needed alligator clips and they work great so I'm happy. I think the hardest part is going to be keeping up with the various tips since they were just sitting in the bag, but that's not a deal breaker. good price too.

These wires looked good but did NOT read 0 ohms but read 0.4 ohms and broke the adjustment ring on first use with regular spade terminals. Crocodile clips show 0 ohms when clamped together! but that's not why I bought this "set". CHEAP plastic. I will NOT be buying a screw tip set again. waste of money.

These wires are flexible and very flexible and the connections seem to be quite strong. I had to screw the tips into the probes with pliers to get the resistance below 0.3 ohms. The other end fits my Fluke 77, but it's stuck, almost forcefully. Hopefully they will loosen up a bit with use. Alligator clips have even less resistance than test leads, and both are good enough for auto electrical work, which is what I do most of the time.

For the price I paid for it the quality seems worth it Clips don't pull very well on small wires on large wires This is normal when you first receive you must cut the plastic to get at it know your depths of your multimeter. I was a bit confused at first, but start with a small cut, keep going, say you have a contact in your multimeter, the screen will show a reading

I was looking for a set of probes to match my multimeter that would give me more options than just sharp things. It serves the purpose pretty well. I wish the alligator clips were a little more precise and/or the kit had those pin clips that you slide out to grab the component pins on the board. After more than a year of use, I am sure that I will buy another set. If it cost more I would probably rate it lower due to the misalignment of the alligator clips, but for the price the set is well…