🚦 FXC 2x 24W Flash Strobe Controller Flasher Module for LED Brake Light Tail Stop Light 12-30V" - Enhanced SEO: "FXC 2x 24W Flash Strobe Controller Flasher Module for LED Brake and Tail Lights (12-30V) Review

Doesn't work on VW or Audi and I think on BMW too because they are German. But the problem was that the taillights of German cars were pulsing. So if you have a good multimeter and set the minimum and maximum values, you will see that the minimum value is 0V and the maximum value is 12V. The voltage jumps up and down and prevents the module from working. I just wish someone would have said that before I installed and soldered all my wires. It's repairable, all you need is a capacitor. As with…

Several reviews indicate the module is either burned out or melted. This is probably because it was not plugged in properly. You want to take two black wires and either ground them to bare metal or connect them in PARALLEL with a ground wire. The problem with series installation is that other circuits can share the same ground. For example the ground of my 3rd brake light is also the ground of the rear heater and can see currents up to 50 amps. If I cut off this ground and connected this module

Very satisfied with this product. I ordered 6 of these to pair with my 2008 Nissan Maxima and 2005 Nissan Altima. Both of my cars have factory LEDs for the third brake light so those turn signals worked fine with them. My left and right taillights for both cars have factory 3057/3157 brake bulbs. Those turn signals worked with those bulbs, but I wasn't happy. Incandescent bulbs skipped the first cycle of 4 fast flashes and then continued to operate normally with 4 slow flashes. I decided to…

This article is worth its money. HOWEVER, it is absolutely NOT easy to install. Unless you fully understand the schematic you are installing the strobe controller into, the installation process will take time and require a lot of trial and error. Once you install it, it works without any problems. There are no instructions included, I assume this is because the seller suggests that if you buy such a product you should already know how to connect it. I have a lot of experience with electronics…

My Dual Sport has an aftermarket Baja Designs fender taillight. The tail light uses 3 wires for ground, tail light and brake light. When I plugged in a Purishion Flash Controller (GS-100A) and turned the ignition on, the taillight went through a series of flashes and the brake did nothing after that. I've tried all combinations of cable connections with no success. I even wondered if I was wrong about which wire was the tail light and brake light. Now I turned on the second light when one of…