Enhanced Rear Track Bar Bracket by Rough Country for 2007-2018 Jeep Wrangler JK | Model 1167 Review

Bought for my jk. It was relatively easy to install and kept all of my suspension geometry right where it was supposed to be!

To be honest I think this design is better than some of the other types that cost more. Replaced one of the other brackets with this one after I bent it. This design looks better

Easy to install. 1 hole you will need to drill as part of a secure installation but it is detailed in the instructions. Part of my 2.5" lift kit.

Easy Installation. Bought in place of the matching SuperLift version that came with my kit as it was over half the price and looked like a better design. Def would buy again.

Perfect fit and quick installation when adding a lift. It's also nice to know that if the woman wants to step up from 2.5 inches, I can use the same mount for 4 inches and 6 inches.

No amount of impact on a bent original mount will straighten it just enough to install. The mount is well made and designed to fit an OEM mount that hasn't been damaged by Neanderthal travel :-) The seller understood and took the mount back with no fuss. I ended up having to cut the bearing mount off and replace it with welding.

works as it should. Very good fit. I refused to drill a hole in the factory mount. If he fails because of that, it's me, not Rough Contry. But even without drilling a hole, it's still very secure due to the other three screws holding it. Highly recommend for a budget facelift.

This was relatively easy to install on my 2007 2 door JK with 2.5" lift. coil spring. I suspect this is because I haven't replaced the rear arms yet and the coil spring is slightly bent due to axle tilt (I could be wrong). My solution was to raise the frame so I had room to insert the cross member into the bracket and insert the bolt from the opposite side, then lower the entire bracket onto the axle bracket. on the spring side of the clevis, which provides the necessary clearance to avoid…