📏 Sherline LM 1000 - Trailer Tongue Weight Scale for Precise 1000LB Measurement and Enhanced SEO Review

Ours sags and does not allow the wood spacer to be reinserted. The instructions say not to lift at the top. To be honest I would load your trailer once or within 100-200 pounds and hit the weight to determine the weight of your tongue. Google is your friend. This thing became a paperweight for me after trying to use it. This is a pain as you have to line everything up as this sits on top of your hitch. Lots of poetry work in front of the weigh station.

This scale is mandatory. I am using it on a single axle trailer and need reliable readings. I've found that after the weight is applied to the weight, I have to wiggle the pendant's tongue from side to side to get a more accurate reading, in my opinion. Typically this is a difference in readings of 40 to 50 pounds (it was 100 pounds). You must be sure that your installation is stable and will not fall off the scales. By the way, who designs a product that falls apart if you don't get it right?

Good scale to read the weight of my trailer. I've found that using a jack and a clutch lift works best for me. 4 out of 5 only because you have to take multiple measurements to get the right weight. The first lift could be 840 lbs, the second 800 lbs, the third and another 780 lbs. After he calmed down, the tongue constantly showed 780 pounds. Very simple construction, the hydraulic pressure corresponds to the pressure gauge displayed in pounds. I believe the first few readings can set the…

Although I bought a new one from Revain the first thing I got was an open box with clues as to what was wrong (sticky sensor) and what support the previous owner spoke to. I sent it back and had to pay another $20 for a replacement because the price went up. I bought this item because my single-axle trailer can vary greatly in the vertical load. For me, knowing it's loaded correctly is worth paying for. However, I know this is a niche product and that adds to the price, but it's just a plunger…

They're essential when you need them. Would you rather risk handling an unsafe load and destroying $10 of your $1,000 worth of gear, or have the peace of mind knowing you're pulling within your weight limit? The instruction manual that comes with it is fantastic and should be a MUST for anyone towing a trailer. Essentially explains 100 different safe towing tidbits in detail. I knew a lot of information, but still learned a lot just from the instruction manual. I can't comment on the accuracy…

The device may have been defective but here is what I experienced. The device arrived well packaged and protected. Stopped block to protect piston and bubble wrap. No problem. The first step was to put a famous £300 source on it. I saw immediately that the gauge/scale was stuck when I put a weight on the piston. He was the first to stop at #80 when full weight was applied. I then tapped the sensor and it jumped to #210 and got stuck. I tapped it again and it got stuck somewhere at 220 and never

Definitely much more convenient than "4x4 bars, bricks, scales, pipes, tape measure and calculator". I used a jack to get the scale in position and got a reading of 310 pounds, which is about what I expected given the current load and balance of my trailer. When he jumped on the hitch he went up to almost 500 pounds and I'm 185 pounds so I think that's pretty accurate. It feels very well made. The instructions (and other reviewers) warn against lifting it by the butt (the black part), and its…

I started with the Weigh Safe ball mount with weights. The first one I read was £100. from the box. When I emailed the company they said there was no way to calibrate the scale and they would send new ones if I just sent back the faulty ones. The Weigh Safe replacement read 50 pounds. from the box. I ended up sending it back for a refund as they are obviously junk. So I turned to this scale further. When I received it the scale showed 0 pounds. Hooray! What a concept! No weight = 0 pounds…

This 1000 lb Sherline LM 1000 Trailer Tongue Scale is worth its weight in gold. MUCH better than using joists, dowels and floor scales. I just put it on my jack and jacked it up so it was pressing against the center of the trailer's tongue hitch, lifting the trailer's leg off the ground. A quick check to make sure everything is level, a few light shakes on the trailer tongue to ensure the weighing piston is fully seated, and voilà: accurate tongue weight measurements in less than five minutes…